We source the metal for each job from mills and stockists, with mill certificates, or work with material you supply. Turkish trade names such as ST37, ST52 and DKP are shown next to the European (EN) grade.
Carbon steel – ST37
Siyah sac / yapı çeliği · ST37
General structural steel, the most common choice for frames, brackets and fabricated parts.
- Grades
- S235JR (formerly St37-2, DIN 17100)
- Standard
- EN 10025-2
- Forms
- Hot-rolled sheet and plate, pickled (dekape) sheet, sections, tube, flat and round bar, checker plate
Easy to cut, bend and weld. Needs paint or galvanising against rust.
Carbon steel – ST52
Yüksek mukavemetli çelik · ST52
Higher strength structural steel for load-bearing frames, machinery and lifting parts.
- Grades
- S355J2 / S355JR (formerly St52-3)
- Standard
- EN 10025-2
- Forms
- Plate, sections, hollow sections, bar
Allows thinner, lighter parts. Thick plate may need pre-heating before welding.
DKP – cold-rolled sheet
DKP sac (soğuk haddelenmiş)
Smooth, accurate thin sheet for enclosures, panels, cabinets and formed parts.
- Grades
- DC01, DC03, DC04
- Standard
- EN 10130
- Forms
- Sheet and coil, typically up to about 3 mm
Very good for bending and painting. Rusts without coating; kept dry and oiled.
Galvanised steel
Galvaniz sac ve sıcak daldırma galvaniz
Zinc-coated steel for outdoor parts, ducts, roofing details and agricultural equipment.
- Grades
- DX51D+Z (Z100–Z275 coating); S235/S355 parts hot-dip galvanised after fabrication
- Standard
- EN 10346; EN ISO 1461 (hot-dip galvanising)
- Forms
- Galvanised sheet and coil, galvanised tube; finished parts galvanised by partners
Welding burns the zinc locally, so welds are touched up. Painting needs a suitable primer or duplex system.
Stainless steel
Paslanmaz çelik
Corrosion-resistant steel for food equipment, kitchens, railings, chemical and marine use.
- Grades
- 304 / 1.4301, 316L / 1.4404, 430 / 1.4016
- Standard
- EN 10088-2
- Forms
- Sheet (2B, brushed, mirror), plate, tube, bar, checker plate
Cut and welded with separate tools to avoid contamination; welds pickled and passivated. Usually not painted.
Aluminium
Alüminyum
Light metal for covers, panels, vehicle bodies, frames and architectural parts.
- Grades
- 1050, 5754, 5083, 6061 / 6082 (extrusions)
- Standard
- EN 485, EN 573, EN 755
- Forms
- Sheet, plate, checker (tread) plate, extruded profiles and tube
Welded by TIG or MIG with filler wire; powder coating or anodising for finish.
Corten – weathering steel
Corten çelik (patinalı)
Steel that forms a stable rust-coloured layer, used for facades, landscaping, planters and signs.
- Grades
- S355J2W (Corten A type)
- Standard
- EN 10025-5
- Forms
- Sheet and plate, laser-cut panels
Left unpainted on purpose. Matching welding wire is used so welds weather the same colour.